Q: Can I get my dies re-ruled or revised?
A: We can re-rule or revise dies of almost any type, which is often cheaper than a new tool.

Q: Will you re-rule dies from other vendors?
A: Yes, many of the dies that we re-rule or revise are from other vendors.

Q: Do you make clear dies? Don't they break easily?
A: We use a clear material that is stronger and less brittle than most of our competitors dies. This material is a bit more expensive initially, but in the long-run it is more economical.

Q: How accurate are steel rule dies?
A: We can guarantee dies that are +/- 0.005 inches in most base materials. We can also incorporate hard-tool punches when necessary.

Q: Can you make a die from a sample?
A: Yes, in fact we can copy a sample to a high degree of accuracy and even return it to a close approximation of its original dimensions. This increases time the tool will remain in tolerance and thus it's overall life.

Q: Can I send you computerized drawings and die-lines by e-mail?
A: Yes, just go to the Contact Us page and send it as an attachment in any of these formats: (dwg, dxf, pdf, ai).

Q: How long do I have to wait for a quote?
A: We will quote any job within 1 hour and you can submit a request for quote online from our Quotes page.